您好,欢迎来到济南通宇恒成自动化工程有限公司网站!

服务热线

当前位置: 首页- 新闻中心 > 公司动态
常见问题
新闻中心

抽屉卡住、跳闸频发的根,常在订货那张表上

发布时间:2026-11-04 来源:http://www.tongyuhengcheng.com/ 浏览量:

低压配电室里,模块化抽出式柜子被当“标准件”买,是项目后期麻烦的开始。同叫MNS结构,参数没锁死,现场就会出怪现象:抽屉推不到位、备件互换不上、大电流回路夏天温升报警。

In the low-voltage distribution room, modular pull-out cabinets were purchased as "standard components", which marked the beginning of troubles in the later stages of the project. Also known as MNS structure, if the parameters are not locked, strange phenomena will occur on site: drawers cannot be pushed in place, spare parts cannot be exchanged, and high current circuits will trigger temperature rise alarms in summer.

base64_image

订货前先把这张表对齐:

Align this table before placing an order:

模数别贪密:8E/4小抽屉适合小控制回路,但电缆粗、元器件多时硬塞会接线崩溃,留20%备用单元比塞满更省钱。

Don't be too picky about modulus: 8E/4 small drawers are suitable for small control circuits, but if the cables are thick and there are too many components, hard plugs can cause wiring breakdowns. Keeping 20% spare units is more cost-effective than filling them up.

短路耐受要对标变压器:变压器出口预期短路电流常冲50kA以上,Icw和分断能力按系统算,不按样本下限选。

Short circuit withstand should be compared with the transformer: the expected short-circuit current at the transformer outlet is often above 50kA, and the Icw and breaking capacity are calculated according to the system, not selected according to the lower limit of the sample.

环境降容写进技术协议:配电室超35℃、靠墙闷热、变频软起集中布置,载流量按0.7–0.8系数留余量。

Environmental capacity reduction is included in the technical agreement: the distribution room exceeds 35 ℃, is stuffy against the wall, and is centrally arranged with variable frequency soft start. The current carrying capacity is reserved with a margin of 0.7-0.8 coefficient.

三室隔离、垂直母线绝缘、抽屉五位置机械联锁(连接/试验/断开/隔离/移出)建议列进验收项,不止看IP30外观。

Three room isolation, vertical busbar insulation, and drawer five position mechanical interlocking (connection/test/disconnection/isolation/removal) must be included in the acceptance items, not just the appearance of IP30.

现场投运三步别跳:

Three steps for on-site operation: Do not jump:

兆欧表测主回路对地、相间绝缘,通流前先紧力矩;

Measure the insulation of the main circuit to ground and between phases with a megohmmeter, and tighten the torque before passing current;

抽屉空推三次,手感应顺、位置指示准,合闸态摇不动;

The drawer should be pushed three times empty, with a smooth feel and accurate position indication. It should not shake when closed;

带载后用红外测温,触头、母排搭接处温升超标就查接触压力和镀层。

After loading, use infrared temperature measurement. If the temperature rise at the contact and busbar overlap exceeds the standard, check the contact pressure and coating.

日常维保抓三件事:清灰不积粉尘、导轨用专用脂不长黄油泥、每年紧一次母排螺栓。触头发紫别砂纸打磨继续用,直接换。

Daily maintenance should focus on three things: cleaning dust to prevent dust accumulation, using special grease for guide rails to prevent grease from growing, and tightening the busbar bolts once a year. Rub your hair with purple sandpaper and continue to use, just replace it.

柜子不是铁壳拼装,是“回路可隔离的运行系统”。前期把模数、分断、散热、联锁写清楚,后期停机时间能砍掉一大半。

The cabinet is not assembled with an iron shell, but a "circuit isolatable operating system". In the early stage, the module, breaking, heat dissipation, and interlocking should be clearly written, and in the later stage, the downtime can be reduced by half.

首页首页 产品产品 电话电话 置顶置顶