您好,欢迎来到济南通宇恒成自动化工程有限公司网站!

服务热线

当前位置: 首页- 新闻中心 > 公司动态
常见问题
新闻中心

配电室多花几万,可能就栽在“柜型”两个字上

发布时间:2026-10-26 来源:http://www.tongyuhengcheng.com/ 浏览量:

很多厂区扩产、机房改造,图纸一出来就急着比价,结果柜子装完才发现:要么检修必停整段母线,要么后期加一路都没地方塞抽屉。问题不在贵不贵,而在“结构”和“参数”没对上场景。

Many factory areas are expanding production and computer room renovations, and as soon as the drawings are out, they rush to compare prices. However, after the cabinets are installed, they realize that either the entire section of the busbar must be stopped for maintenance, or there is no place to put drawers when adding a new line later. The problem is not whether it is expensive or not, but rather that the "structure" and "parameters" do not match the scenario.

微信图片_202009081137222

先分清三兄弟:

First, distinguish the three brothers:

GGD 固定式:元件焊死在柜里,便宜、载流大、皮实。适合回路少、负荷稳、允许停电维护的车间进线柜。

GGD fixed type: The components are soldered in the cabinet, which is cheap, high current carrying, and sturdy. Suitable for workshop incoming cabinets with few circuits, stable load, and power outage maintenance allowed.

GCS 抽出式:每路做成抽屉,坏一路抽一路,其他照常跑。工厂动力配电、回路多的楼宇非常常用,性价比居中。

GCS pull-out type: Each path is made into a drawer, one path is damaged and pulled out, while others run as usual. Buildings with multiple power distribution and circuits in factories are the most commonly used, with a moderate cost-effectiveness.

MNS 模数化抽屉柜:模数更细、密度更高,双面操作、扩容方便,数据中心和连续生产线优选,价格也非常高。

MNS modular drawer cabinet: finer module, higher density, double-sided operation, easy expansion, preferred for data centers and continuous production lines, with the highest price.

选型别背型号,问自己三句:

Choose a model without memorizing it, ask yourself three questions:

停一次电损失多少?损失小选 GGD,损失大选抽出式。

How much does it cost to stop electricity once? Loss small selection GGD, loss large selection pull-out formula.

未来两年加不加回路?要扩容别用固定柜。

Will there be a circuit added in the next two years? Do not use fixed cabinets for expansion.

运维人员会不会换抽屉?不会换就别盲目上 MNS。

Will the maintenance personnel change the drawers? If you don't know how to change, don't blindly join MNS.

再到货盯死三条红线:

Upon arrival, mark three red lines:

主母线用 T2 铜排、截面按满负荷留 20% 余量,别让厂家用铜包铝顶替;

Use T2 copper bars for the main busbar, and leave a 20% margin for the cross-section at full load. Do not let the manufacturer replace it with copper-clad aluminum;

断路器、接触器品牌写进合同附件,到货逐台对铭牌;

The brands of circuit breakers and contactors shall be included in the contract attachments, and nameplates shall be provided for each unit upon arrival;

防护等级按环境定,干燥配电房 IP30 够用,水泵房、户外至少 IP54,别拿室内柜扛凝露。

The protection level is determined by the environment. IP30 is sufficient for dry distribution rooms, and at least IP54 is required for water pump rooms and outdoor areas. Do not carry condensation with indoor cabinets.

非常后补一句容易漏的:送电前建议做绝缘测试和五防联锁验证,柜门打开能否切断主回路、抽屉带电能否被锁住,这两步不做,后面再贵的柜子也白搭。

One last sentence that is easy to miss: Insulation testing and five proof interlock verification must be done before power transmission. If the cabinet door can be opened to cut off the main circuit and if the drawer is locked when it is electrified, these two steps will be useless for any expensive cabinet later on.

把“柜型看停电代价、母排看材质、防护看环境”这三句记牢,成套方案基本不会买错。

Remember the three sentences of "cabinet type depends on power outage cost, busbar depends on material, and protection depends on environment", and the complete set of solutions will not be purchased incorrectly.

首页首页 产品产品 电话电话 置顶置顶